In order to provide quality products, Shree Dev Narayan Refractories deliver to their market, materials of the highest quality consistent with a resources of the research and development facilities based in Bhilwara, Rajasthan (India). The primary objective of the Shree Dev Narayan is to research, develop and manufacture highest quality of Refractory products, which deliver measurable and tangible results to the customers.

Shree Dev Narayan Refractories operate a policy of continuous product development with from time to time results in the introduction of new products, some of which are included in this catalogue

Technical support to the Shree Dev Narayan Refractories range of products is provided by the intensive research and development faculties of Shree Dev Narayan Refractories, and by the technical Sales Division. Selection of material for the often complex lining requirements for steel ladle applications are generally made after discussion with the customer, to provide the best possible lining balance that offers optimum performance in terms of cost and operation.

The availability of raw material, reliable power supply, skilled manpower, spares and consumables, communication and transportation facilities and easy accessibility to various other resources given the unit an edge over its competitors. In a short span of time SHREE DEV NARAYAN REFRACTORIES has emerged a market leader in insulation refractories in the region.

A fire brick, firebrick, or refractory brick is a block of refractory ceramic material used in lining furnaces and kilns.

A refractory brick is built primarily to withstand temperature, but should also usually have a low thermal conductivity to save energy. Usually dense firebricks are used in applications with extreme mechanical, chemical, or thermal stresses, such as the inside of a wood-fired kiln or a furnace, which is subject to abrasion from wood, fluxing from ash or slag, and high temperatures. In other, less harsh situations, such as a natural gas fired kiln, more porous bricks are a better choice. They are weaker, but they are much lighter, easier to form, and insulate far better than dense bricks. In any case, firebricks should not spall under rapid temperature change, and their strength should hold up well during rapid temperature changes.

To achieve high quality & High Productivity, we are using Fleet of heavy duty press for higher dense material & High temperature tunnel kiln for controlled and uniform firing.

Raw material A ball clay, it is soft in nature supplied by mines in lumps, it dissolves in water with thin minutes.

Raw matrrial B- Insulating broken pcs it is waste product . porous , and soft it is powdered by hammer Mill. The waste powder gathered dust collectors of brick grinding and cutting section is so used. So nothing is waste in the factory.

Raw material C – Sawdust it is a waste product obtained form wood cutting. It is sieved by rotary sieve and used in the brick as cumbastible to get Pores in the product.